CNS aerial work platform reminds that when operating the bending arm aerial work platform, it is necessary to wear a suitable full-body safety sling, lapping line or automatic retractable lifeline.
CNS aerial work platform reminds that when operating the bending arm aerial work platform, it is necessary to wear a suitable full-body safety sling, lapping line or automatic retractable lifeline. Most operators do not understand the possibility of the platform boom popping out, and the smallest vibration at the base of the equipment can cause a violent vibration on the platform, throwing the operator into the air. In the event of such an eventuality, wearing appropriate fall protection installation can reduce the likelihood of serious injury or death.
CNS aerial work platform discusses the operation specifications of the aerial work platform with curved arm
1, the driver must hold the bus driving license.
2, the auxiliary transmission must be removed from the hydraulic pump.
3. Pay attention to the height of Bridges and tunnels.
4, the general speed does not exceed 30 km/h, suburban does not exceed 40 km/h.
5, the operation hopper (platform) refused to stay personnel.
CNS aerial work platform talk about bending arm aerial work platform operation specifications - work
1, the parking position should be solid in the air, the vehicle inclination is not more than 3°, and turn on the warning flashing light.
2, operation, the operator should pay attention to the bucket (platform), arm and upper and lower pressure wire, telephone lines and buildings, trees, billboards, lighting and other things safe interval.
3, the driver on duty, as the air and pay attention to the safety of traffic protection work.
4, the use of working height of 25 meters above the operation vehicle, in addition to set up a safety sign and guardrail, air guardian in addition to the driver, but also set 1-2 people dedicated to enhance monitoring.
5, in the process of operation, if the hydraulic system is found to have abnormal sounds or sudden oil leakage, the work should be stopped, to be inspected or repaired before continuing to work.
6. When the hydraulic system is faulty and the operation arm cannot move, the staff on the operation bucket (platform) should be evacuated safely and the professional maintenance personnel should be notified for disposal.
7. At the end of the operation, the operation bucket (platform), the operation arm is reset, the support leg is put away, the hydraulic oil pump is removed, and the hand brake is released, and the driving can be started.
8. Start the oil pump, step on the car clutch, pull the overhand brake, the gearbox is in neutral, pull the clutch rod of the hydraulic oil pump, so that the hydraulic oil pump is in working condition.
9, operation height and wind (Beaufort wind level 6 and below suitable height of 10 meters below the wind level 5 can be suitable height of 11~20 meters below the wind level 4 and below suitable height of 21~30 meters below the operation.
